ProLiant ML530 Servers Maintenance and Service Guide

6 Compaq ProLiant ML530 Servers Maintenance and Service Guide
is failed 3-43
is undergoing drive
recovery 3-43
needs replacing 3-43
upload code not
readable 3-43
was inadvertently
replaced 3-43
Drive Monitoring features are
unobtainable 3-43
Drive Monitoring is NOT
enabled 3-43
Drive time-out occurred on
physical drive bay X 3-43
Drive X indicates
position Y 3-43
Duplicate write memory
error 3-43
Error occurred reading RIS copy
from SCSI Port X 3-44
Fatal ROM Error 3-8
FYI, Drive (bay) X is
non-Compaq supplied 3-44
Identify controller data did not
match NVRAM 3-44
Identify logical drive data did not
match NVRAM 3-44
Incorrect Drive Replaced 3-21
Insufficient adapter
resources 3-44
Less than 75% batteries at
sufficient voltage 3-44
Logical drive X failed due to
cache error 3-44
Logical drive X status
Failed 3-45
Interim Recovery 3-45
Loose Cable Detected 3-45
Needs Recover 3-45
Overheated 3-45
Overheating 3-45
Recovering 3-45
Wrong Drive
Replaced 3-45
Loose cable detected, logical
drives may be marked
FAILED 3-46
Mirror data miscompare 3-46
No configuration for accelerator
board 3-46
NVRAM configuration present,
controller not detected 3-46
Permanently disabled 3-40
RESUME - F1 key 3-23
RIS copies between drives do not
match 3-47
Run System Configuration
Utility 3-23
SCSI Port X Drive ID X
failed - Replace 3-48
firmware needs
upgrading 3-48
has exceeded
threshold(s) 3-47
has loose cable 3-48
is not stamped for
monitoring 3-48
replaced on a good
volume 3-48
RIS copy mismatch 3-48
SCSI Port X drive ID Y firmware
needs upgrading 3-48
Set configuration command
issued 3-48
Soft Firmware Upgrade
required 3-48
Unable to communicate with
drive on SCSI Port X 3-49
Unknown disable code 3-49
Unrecoverable read error 3-49
Unsupported Processor Detected
System Halted 3-8
Warning bit detected 3-50
Warning, Drive Write Cache
enabled on X 3-49
Write memory error 3-50
Wrong Accelerator 3-50
ESD See electrostatic discharge
Event List
printing 3-52
viewing 3-51
event messages, defined 3-53
event type
ASR-2, system lockup 3-54
fan failure 3-53
machine environment
Fan Inserted 3-53
Fan Removed 3-53
Fans Not Redundant 3-53
Overheat Condition 3-53
main memory
Correctable Error threshold
exceeded 3-53
Uncorrectable Error 3-53
operating system
automatic OS
shutdown 3-54
system crash 3-54
PCI bus error 3-53
power subsystem
AC voltage problem 3-54
power AC overload 3-54