ProLiant ML530 Servers Maintenance and Service Guide
Table Of Contents
- Compaq ProLiant ML530 Servers Maintenance and Service Guide
- Notice Page
- Table of Contents
- About This Guide
- Chapter 1: Illustrated Parts List
- Chapter 2: Removal and Replacement Procedures
- Electrostatic Discharge Information
- Symbols on Equipment
- Preparation Procedures
- Tower Model Front Bezel Door
- Rack Mount Bezel
- Access Panel
- Fans
- Removable Media and Mass Storage Devices
- Cable Routing Diagrams
- System Board Tray
- System Board Components
- Hot Plug Power Supplies
- Power Backplane Board
- Power On/Standby Switch
- Chapter 3: Diagnostics and Troubleshooting
- Diagnostic Tools Utility Overview
- Default Configuration
- Utilities Access
- Power On Self Test
- Diagnostics Software
- Steps for Diagnostics
- 100–199, Primary Processor Test Error Codes
- 200–299, Memory Test Error Codes
- 300–399, Keyboard Test Error Codes
- 400–499, Parallel Printer Test Error Codes
- 500–599, Video Display Unit Test Error Codes
- 600–699, Diskette Drive Test Error Codes
- 800–899, Video Board Test Error Codes
- 1100–1199, Serial Test Error Codes
- 1200–1299, Modem Communications Test Error Codes
- 1700–1799, Hard Drive Test Error Codes
- 1900–1999, Tape Drive Test Error Codes
- 2400–2499, Advanced VGA Board Test Error Codes
- 6000–6099, Compaq NIC Boards Test Error Codes
- 6500–6599, SCSI Hard Drive Test Error Codes
- 6700–6799, SCSI Tape Drive Test Error Codes
- 8600–8699, Pointing Device Interface Test Error Codes
- Array Diagnostic Utility
- Integrated Management Log
- Rapid Error Recovery
- Remote Service Features
- ROMPaq Error Recovery Options
- Compaq Insight Manager
- Chapter 4: Connectors, Switches, Jumpers, and LED Indicators
- Chapter 5: Physical and Operating Specifications
- Index
3-8 Compaq ProLiant ML530 Servers Maintenance and Service Guide
Table 3-2
POST Error Messages
Error Code Audible Beeps Probable Source of Problem Recommended Action
A Critical Error
occurred prior to this
power-up
None A catastrophic system error,
which caused the server to
crash, has been logged.
Run Diagnostics. Replace the
failed assembly as indicated.
Unsupported
Processor Detected
System Halted
1 long, 1 short Processor not supported by
current system ROM.
Check documentation for
supported processors, and if
supported, remove the
processor and update the
system to the latest ROM. Then
reinstall the processor.
FATAL ROM ERROR:
The System ROM is
not properly
programmed
1 long, 1 short ROM programmed in the factory
incorrectly.
Flash the ROM or replace the
physical ROM part.
101-ROM Error 1 long, 1 short System ROM checksum Run Diagnostics. Replace the
failed assembly as indicated.
101-I/O ROM Error None Options ROM checksum Run Diagnostics. Replace the
failed assembly as indicated.
102-System Board
Failure
None DMA, timers, and so on Replace the system board. Run
the Compaq System
Configuration Utility.
104-ASR-2 Timer
Failure
None System board failure Run Diagnostics. Replace the
failed assembly as indicated.
105-Current System
ROM is corrupt –
now booting
redundant System
ROM
2 long Nonbooted ROM image is
corrupt.
Flash the ROM utilizing
ROMPaq.
162-System Options
Not Set
2 short Configuration incorrect Run the System Configuration
Utility and correct the
configuration.
163-Time & Date Not
Set
2 short Invalid time or date in
configuration memory
Run the System Configuration
Utility and correct the time or
date.
164-Memory Size
Error
2 short Configuration memory incorrect Run the System Configuration
Utility and correct memory
configuration.
172-Configuration
Nonvolatile Memory
Invalid
None Nonvolatile configuration corrupt
or jumper installed.
Run the System Configuration
Utility and correct.
173-Slot ID
Mismatch
None Board replaced, configuration not
updated.
Run the System Configuration
Utility and correct.
continued