HP ProLiant ML570 Generation 2 Server Setup and Installation Guide

Server Configuration and Utilities
8-12 HP ProLiant ML570 Generation 2 Server Setup and Installation Guide
HP CONFIDENTIAL
Writer: Wendy Wing File Name: i-ch8 Server Configuration and Utilities.doc
Codename: Time Bandit Part Number: 223960-002 Last Saved On: 8/22/02 11:17 AM
There are two methods of accessing the redundant ROM:
• Switching to the backup ROM through RBSU
• Manually forcing to the backup ROM through the system maintenance switch
(SW4)
Switching to the Backup ROM through the ROM-Based Setup
Utility
Use ROMPaq utilities to create a backup ROM image before upgrading the
configuration or to restore saved ROM data.
1. Access RBSU by pressing the F9 key during power up when the prompt displays
in the lower right corner of the screen.
2. Select Advanced Options.
3. Select ROM Selection.
4. Select one of the ROM banks as the system ROM.
5. Press the Enter key.
6. Press the Esc key to exit the current menu, or press the Esc key, then press the
F10 key at the prompt to exit RBSU.
7. Restart the server.
If both the current and backup versions of the ROM are corrupt, the server
automatically enters the ROMPaq disaster recovery mode. To perform this
procedure, refer to the “ROMPaq Disaster Recovery” section in Appendix E,
“Troubleshooting.”