HP ProLiant SB460c SAN Gateway Storage Server installation instructions (AN583-96010, September 2008)

ManualsBrandsHP ManualsStorageHP ProLiant NAS Gateways

HP ProLiant

SB460c SAN Gateway Storage

Server install

ation instructions

L.P.

First edition: September 2008

The info

rmationinthisdocumentissubjecttochangewithout

notice.

Printed in Puerto Rico

www.hp.com

N58396010*

Over view

Installation of a storage blade requires the following steps:

1. Install and conﬁgure an HP BladeSystem c-Class enclosure.

2. Install any blade options.

3. Install interconnect modules in the enclosure.

4. Connect the interconnect modules to the network.

5. Install a storage blade.

6. Complete the storage blade conﬁ guration.

Installing an HP BladeSystem c-Class

enclosure

Before perf

orming any blade-speciﬁc procedures, install an HP

BladeSyste

mc-Classenclosure.

The most cur

rent documentation for blades and other HP

BladeSyste

m components is available at the HP website

(http://w

ww.hp.com/go/bladesystem/documentation).

Documentation is also available in the following locations:

• Documentation CD that ships with the enclosure

• HP Business Support Center website (http://w ww.hp.com/support)

• HP Technical Documentation website (http://docs.hp.com)

Installing blade options

Before installing and initializing the storage blade, install any

blade options, such as an additional mezzanine card. For blade

options installation information, see the HP ProLiant BL460c Server

Blade User Guide on the Documentation CD or on the HP website

(http://www.hp.com/go/bladesystem /documentation).

Installing interconnect modules

For speciﬁc steps to i n stall interconnect modules, see the documentation

that sh ips with the interconnect module.

To support network connections for speciﬁc signals, install an

interconnect module in the bay corresponding to the embedded NIC or

mezzanine signals.

Page 1

Summary of content (3 pages)

PAGE 1
HP ProLiant SB460c SAN Gateway Storage Server installation instructions Overview Installation of a storage blade requires the following steps: 1. Install and configure an HP BladeSystem c-Class enclosure. 2. Install any blade options. 3. Install interconnect modules in the enclosure. 4. Connect the interconnect modules to the network. 5. Install a storage blade. 6. Complete the storage blade configuration.
PAGE 2
Figure 1 Interconnect bay numbering and device mapping (c7000 enclosure) Blade signal Interconnect bay NIC 1 (embedded) 1 NIC 2 (embedded) 2 Mezzanine 1 3 and 4 Mezzanine 2 5 and 6 Figure 2 Interconnect bay numbering and device mapping (c3000 enclosure) Interconnect bay label 7 and 8 Blade signal Interconnect bay NICs 1 and 2 (embedded) 1 Mezzanine 1 2 Four port cards connect to bay 2 3, 4 • Four port cards • Ports 1 and 3 connect to bay 3 • Ports 2 and 4 connect to bay 4 3, 4 • Four
PAGE 3
Installing a blade IMPORTANT: If your HP SB460c SAN Gateway Storage Server is factory-integrated, the blades are pre-installed in the enclosure. CAUTION: To prevent improper cooling and thermal damage, do not operate the blade or the enclosure unless all hard drive and device bays are populated with either a component or a blank. 1. Remove the blank. Completing the configuration To complete the HP BladeSystem enclosure configuration, see the overview card that ships with the enclosure.