HP ProLiant SL165s G7 Server Installation Instructions

NOTE: Do not over tighten the heat sink’s spring-loaded screws

to prevent them from breaking off.

Installing the DIMM Air Baffle

NOTE: The DIMM air baffle is required for proper thermal

solution.

1. Hold the latch on the top of the DIMM air baffle and align it to the

system board.

2. Press down to make sure the DIMM air baffle completely installed

NOTE: To check and ensure the 2 ribs are installed

between DIMM1 and DIMM2, DIMM11 and DIMM12.

Figure 12 Installing the DIMM air baffle into the tray

Installing the CPU Air Baffle

NOTE: The CPU air baffle is required for proper thermal

solution.

To install the CPU air baffle:

1. Align the CPU air baffle to the tray.

2. Secure the left latch to the left bracket, the middle latch to the

middle bracket and the right latch to the PCIe x16 bracket on the

tray.

3. Press down the CPU air baffle to make sure it completely installed

on the tray.

Figure 13 Installing the CPU air baffle into the tray

Additional Documentation

For additional documentation, refer to HP ProLiant SL165s G7 Server

Easy Set-up CD. You can also access additional information and

documentation from the HP external website, either by connecting

directly or through the Easy Set-up CD.