HP Smart Update Manager 6.0.0 User Guide

DescriptionSuperdome 2 server commands
Example: /device_list
npar1,npar2,blade1/1,blade1/2
Use this argument when the /update_type is ALL or
PARTITIONS. This argument specifies specific partitions
/reboot_list <npar[,npar]…>
to reboot after the partition firmware has been updated.
Valid npar values are npar(number). Do not put any
spaces between parameters.
Example: /reboot_list npar1,npar2
Command-line examples
The following command-line parameter examples can be executed within these environments:
• Firmware:
System ROM◦
◦ Smart Array controller
◦ Hard drives
◦ iLO
• Software—later version of:
HP Insight Diagnostics Online Edition for Windows Server 2003 (cp008097.exe)◦
◦ HP System Management Homepage (HP SMH) for Windows (cp008257.exe)
• HP SUM
◦ Defined groups: Management Servers—three servers (Management Server1, Management
Server2, Management Server3)
Example 1:
This command-line input deploys the latest PSP and firmware components:
hpsum /use_latest /allow_non_bundle_components /silent
Results: All software components and firmware components from the update bundle, which HP
SUM determined must be installed, were installed.
Example 2:
Either of the following command-line inputs can deploy the previous version of the PSP only and
force all the components to be installed:
• hpsum /f:bundle /softwareonly BP000315.xml
• hpsum /b BP000315.xml /f:bundle /softwareonly
Results: All software components and firmware components from the update bundle, which HP
SUM determined must be installed, were installed. No firmware was installed.
Example 3:
This command-line input deploys firmware:
hpsum /romonly
Results: All firmware components that must be installed, were installed. No software was installed.
Example 4:
Command-line interface 45