HP Smart Update Manager 6.0.0 User Guide

Possible valuesDescriptionParameter
Directory pathProvide a single local baseline path.
This action creates an inventory from
SOURCEPATH
the given path instead of the local or
default baseline.
YES, NOThis is a filter switch for use with
bundles. The parameter enables you
USELATEST
to use the latest version of the bundle
when multiple versions of bundles are
listed on the command line.
If no bundles are specified on the
command line, and multiple bundles
are in the directory, this parameter
enables HP SUM to use the bundle
that has the latest version for
installation.
YES, NOSimulates the installation for a test run.
Nothing is installed.
DRYRUN
One or more CLI switchSpecify the HP SUM CLI options inside
the input file, which overrides the
OPTIONS
configuration settings. Parameters can
be separated by a semi-colon, comma,
or a space.
This parameter replaces the
LSPOPTIONS parameter that was
previously supported with LDU.
YesSpecifies that components that use
AMS and WBEM Providers listed as
NOMGMT
No
optional updates on the Components
Selection screen.
In silent mode, HP SUM does not
update AMS or WBEM Providers.
NOTE: You can only configure
SNMP in HP SUM GUI mode.
YES, NOSpecifies that components that use
WMI protocol are available to be
selected for installation.
USEWMI
These components are optional by
default and are not installed unless this
parameter is used. When the
/usewmi parameter is used. This
parameter does not apply to HP
Integrity servers.
YES, NOSpecifies that AMS agentless
management service components are
USEAMS
available to be selected for
installation.
This option will only apply to Gen8
and later servers. If this parameter is
set for a ProLiant G7 and earlier
server model, it will be ignored.
These components are only installed
by default on Gen8 and later servers.
This parameter does not apply to HP
Integrity servers.
52 Using legacy scripts to deploy updates