HP ProLiant SL250s Gen8 Server Maintenance and Service Guide

Removal and replacement procedures 29
Remove the rear GPU cage
1. Power down the server (on page 24).
2. Disconnect all peripheral cables from the server.
3. Remove the server from the chassis (on page 24).
4. Remove the rear GPU cage.
Drive blank
CAUTION: To prevent improper cooling and thermal damage, do not operate the server unless
all bays are populated with either a component or a blank.
To remove the component:
1. Remove the drive blank.
To replace the blank, slide the blank into the bay until it locks into place.
SFF hot-plug drive
CAUTION: To prevent improper cooling and thermal damage, do not operate the server unless
all bays are populated with either a component or a blank.