HP ProLiant SL250s Gen8 Server Maintenance and Service Guide

Removal and replacement procedures 31
To replace the component, reverse the removal procedure.
SFF quick-release drive
To remove the component:
1. Back up all server data on the drive.
2. Power down the server (on page 24).
3. Disconnect all peripheral cables from the server.
4. Remove the server from the chassis (on page 24).
5. If removing a drive from the front GPU cage, remove the front GPU cage (on page 26).
6. Remove the quick-release drive:
a. Slide the drive release latches to the unlocked position.
b. Raise the drive handle.
c. Remove the quick-release drive from the cage.
To replace the component, reverse the removal procedure.
Quick-release drive cage cable assembly
To remove the component:
1. Power down the server (on page 24).
2. Disconnect all peripheral cables from the server.
3. Remove the server from the chassis (on page 24).
WARNING: To reduce the risk of personal injury from hot surfaces, allow the drives and the
internal system components to cool before touching them.
4. Remove the front GPU cage (on page 26).
5. Remove the interposer board assembly (on page 26).