HP ProLiant SL250s Gen8 Server Maintenance and Service Guide

Removal and replacement procedures 51
c.
Finish the installation by completely tightening the screws in the same sequence.
7. Install the processor air baffle.
8. Install the front GPU bracket.
9. Install the interposer board assembly.
10. Install the front GPU cage.
11. Install the server into the chassis.
12. Connect the peripheral cables.
13. Press the Power On/Standby button.
The server exits standby mode and applies full power to the system. The system power LED changes
from amber to green.
System board
To remove the component:
1. Power down the server (on page 24).
2. Disconnect all peripheral cables from the server.
3. Remove the server from the chassis (on page 24).
4. Remove the front GPU cage (on page 26).
5. Remove the interposer board assembly (on page 26).
6. Remove the front GPU bracket (on page 27).
7. Remove the SFF hot-plug drive cage (on page 25).
8. Remove the PCI riser cage (on page 27).
9. Remove the FlexibleLOM riser cage (on page 28).
10. Remove the processor air baffle ("Processor air baffle" on page 44).
11. Remove all DIMMs ("DIMMs" on page 43).
12. Remove the heatsink: