HP ProLiant WS460c Gen8 Workstation Blade with WS460c Graphics Expansion Blade CE Installation Guide

ManualsBrandsHP ManualsServerHP ProLiant WS460c Gen8 Workstation

HP Customer Engineer Installation Instruction

HP Graphics Options for

HP ProLiant WS460c Gen8

Spare

Step 1. Overview

These instructions provide an overview of the HP

ProLiant WS460c G8 Workstation Blade

installation process. For software installation

information, see the Administrator's Guide for

Microsoft Windows on HP ProLiant Blade

Workstations.

The most current documentation for workstation

blades and other HP BladeSystem components is

available at the HP website

(http://www.hp.com/go/bladesystem/documen

tation). Documentation is also available at the

HP Business Support Center website

(http://www.hp.com/support)

Step 2. Determine Installation

Type – Customer Installation vs.

HP Service Installation

This hardware kit can be usedin two different

hardware configurations. Customer installation is

acceptable when installing the Mezzanine

Assembly into a WS460c Blade assembly. For

that configuration, follow these instructions.

If this Mezzanine Assembly is to be installed into

an HP Multi-GPU PCIe graphics board, found in

the HP Proliant Graphics Expansion Blade, it

must be installed by an HP Customer Engineer

using these installation instructions. Customer

Installation may void the warranty.

Step 3. WS460c Multi GPU

Module Removal

• Remove the Multi-GPU Module from the HP

ProLiant Graphics Expansion Blade.

• Identify the MXM Module to be replaced.

Remove the two flat head screws which hold

the MXM Module to the Multi-GPU PCA

sheetmetal tray. Set aside these two screws

for later.

• Remove the plastic top cover from the Multi-

GPU Module.

• Remove screw.

• Pull the MXM board with heatsink attached out

of MXM connector on Mezzanine Adapter

Board. Lift up & pull away from connector.

*784068-001*

754068-001

set forth in the express warranty statements accompanying such products and services. Nothing herein should be construed as constituting an additional warranty. HP shall not be liable for

technical or editorial errors or omissions contained herein.

Part Number 784068-001, June 2014

Summary of content (3 pages)

PAGE 1
HP Customer Engineer Installation Instruction HP Graphics Options for HP ProLiant WS460c Gen8 Spare Step 1. Overview These instructions provide an overview of the HP ProLiant WS460c G8 Workstation Blade installation process. For software installation information, see the Administrator's Guide for Microsoft Windows on HP ProLiant Blade Workstations. The most current documentation for workstation blades and other HP BladeSystem components is available at the HP website (http://www.hp.
PAGE 2
Step 4. Install Multi-Module GPU Heatsink to Hardware Kit MXM Module • • • • • Align the heatsink to the PCA. Secure four heatsink screws in numerical order as shown. Loosen the 4 captive screws shown (1-4) Remove the Heat Sink from the underside of the MXM card, leaving the bracket in place • Remove the tan liner from the heatsink and discard. Remove and discard all tape and the clear cover from 2nd heatsink in the kit. Sign up for updates hp.
PAGE 3
Step 5 Install Multi-GPU MXM Module into the Multi-GPU PCA • Install assembly (MXM with heat sink) into MXM connector on HP MultiGPU carrier PCA. • • Reinstall the clear air flow cover using the 3 screws to secure in place. Attach 2 screws from back of tray into heatsink. Step 6. More Information • • Seat the heatsink assembly into the graphic board slot shown. Secure the heatsink assembly with two screws removed in previous step.