Hardware Reference Guide

9. Slide the drive adapter holding the 2.5-inch drive or drives out of the drive cage.

Figure 2-40 Removing the 2.5-inch drive adapter from the drive cage

10. Remove the four mounting screws from the 2.5-inch hard disc drive adapter. Be sure to keep the

screws together with the blue rubber grommets to use to install a replacement drive.

NOTE: The primary drive is the lower position in the drive cage. If only one drive is to be

installed, it must occupy this position.

Figure 2-41 Removing the mounting screws from the 2.5-inch drive adapter

11. Remove the 2.5-inch hard disc drive(s) from the 2.5-inch drive adapter.

For instructions on installing a hard disc drive, see

Installing a hard disc drive on page 40.

Replacing drives