UPS R3000 XR Models Installation Instructions

Checking the Battery
Recharge Date
Before unpacking the UPS, check the battery recharge date
specified on the battery recharge date label that is affixed to the
shipping carton.
IMPORTANT: Do not use the battery if the recharge date has passed. If the
date on the battery recharge date label has passed without the battery being
recharged, contact an HP authorized service representative for directions.
NOTE: The following label is only an example date. The date on your carton
may be different.
THIS PRODUCT CONTAINS
A NONSPILLABLE BATTERY
Next Recharge Date:
Please refer to Maintenance Section
of Owner's Manual enclosed inside
05-MAR-07
Kit Contents
Documentation
• International Regulatory Compliance guide
• Important Safety Information guide
• Power Products Documentation CD
• Rack and Power Management Pack CD
• This document
Rails
• Rails, with mounting hardware
• Rack template tool 2U (295523-023)
UPS
• UPS chassis
• Battery module
• Electronics module
• Front bezel
• Rear stabilization brackets (2)
• Communications port/option slot, preinstalled (200388-001)
• Remote Emergency Power Off (REPO) port and connector
block
• Cord retention clips
Additional Hardware
The following items are supplied for shipping a rack with a UPS
installed:
• M6 nuts (4)
• M6 flat washers (4)
• M6 split washers (4)
Cables
• The R3000h XR-NA, R3000h XR-JPN, R3000i XR-EURO,
R3000i XR-SCHUKO, R3000i XR-SA, and
R3000e XR-INT’L models ship with:
 Two 10 A, 1.83-meter (6-foot) IEC-to-IEC power cords
(142263-001)
 Two 10 A, 2.44-meter (8-foot) IEC-to-IEC power cords
(142263-002)
 Two 10 A, 3.05-meter (10-foot) IEC-to-IEC power cords
(142263-003), for load equipment power
 A 3.66-meter (12-foot) UPS/computer interface cable
(201092-002)
• The R3000 XR-NA and R3000j XR-JPN models ship with a
non-detachable input power cord with an L 5-30 plug and a
3.66-meter (12-foot) UPS/computer interface cable
(201092-002).
• The R3000h XR-NA and R3000h XR-JPN models ship with a
non-detachable input power cord with an L 6-20 plug.
• The R3000e XR-INT'L models ship with a non-detachable
input power cord. It has an IEC 320-C19 input power
receptacle for a country specific cord.
NOTE: All models ship with a computer interface cable. The computer
interface cable is not needed for normal operation. To administer the UPS
with power management software, connect the interface cable between the
UPS communications port and the serial port on the host computer.
Tools and Materials Required
The following tools are required:
• Medium flat-bladed screwdriver
• #2 Phillips screwdriver
The following items are supplied with the rack:
• Screws
• Cage nuts
• Cage nut-fitting tool