UPS R3000 XR Models User Guide

Configuration
3-4 HP Uninterruptible Power System R3000 XR Models User Guide
Changing Configuration Parameters
To change configuration parameters:
1. Place the UPS in Configure mode by pressing and holding the Configure button until the
Configure Mode On LED turns solid green.
When the Configure button is released, the configurable LEDs flash and the configured
LED illuminates.
2. To advance to the appropriate voltage configuration, press the On button. The selected
voltage configuration LED flashes. Activate the voltage configuration by pressing the
Standby button. The previously selected configuration parameter LED turns off and the
selected LED is illuminated.
NOTE: Only one nominal utility voltage can be configured. When setting voltage configuration
parameters, selecting an On value for any one parameter automatically sets the other three
possibilities to Off.
3. To toggle the Site Wiring Fault option from active to inactive, press the On button to
advance to the Site Wiring Fault LED, then press the Standby button to disable.
4. To accept the configuration settings and exit Configure mode, press the Test/Alarm Reset
button.
NOTE: If the unit remains idle for two minutes, Configure mode times out and the configuration settings
are not stored.