UPS R6000 Models User Guide

Operation
HP Uninterruptible Power System R6000 Models User Guide 2-7
Silencing an Audible Alarm
To silence the alarm, press the Test/Alarm Reset button (1) and hold for two seconds.
Figure 2-7: Test/Alarm Reset button
IMPORTANT: Although the Test/Alarm Reset button silences the audible alarm, the condition that
caused the alarm still exists. Refer to Chapter 5, “Troubleshooting,” for information on what to do if the
UPS detects an alarm condition.
The silencing of the alarm is based on the current set of alarms that is present when the button is
pressed. If the alarm set changes and at least one alarm condition still exists, the audible alarm
reactivates.
If the condition that caused the alarm is a utility power failure, the alarm is silenced shortly after utility
power is restored.
Shutting Down the System
To shut down the system:
1. Place the UPS in Standby mode by pressing the Standby button.
2. Disconnect the AC mains by opening the switch or circuit breaker at the utility panel.