UPS R6000 Models User Guide

LCD Configuration and Status
HP Uninterruptible Power System R6000 Models User Guide 3-5
Status
Select Status on the Main Menu and press the Enter button to view the status or active alarms
for the UPS.
Main Menu
→ Status
UPS Status + Receptacle Status
Select UPS Status + Receptacle Status from the Status menu to view information about the
system. The following LCD display example shows that the UPS has detected no problems.
Load segments 1, 4, and 5 are on. Load segments 2 and 3 are off.
System Normal
ON: 1 - - 4 5
UPS Status + Active Alarm Count
Select UPS Status + Active Alarm Count from the Status menu to view the number of current
alarms. In this example, the UPS has detected no problems and there are no alarms.
System Normal
0 Alarms
Table 3-2: Active Alarm Count Options
LCD Display Explanation
On Battery
x Alarms
The UPS has switched from utility voltage input to battery power.
On Bypass
x Alarms
The UPS has been placed in Bypass mode.
Load Power Off
x Alarms
The power feeding the UPS-protected devices has terminated.
Load Power On
x Alarms
Utility power has been restored to the devices backed up by the UPS.
Overload
x Alarms
There are too many loads attached to the UPS.