UPS R6000 Models User Guide

LCD Configuration and Status
3-8 HP Uninterruptible Power System R6000 Models User Guide
Table 3-4: Active Alarms continued
LCD Display Explanation
x Alarms
UPS On Battery
The UPS switched to battery power. The
LED illuminates yellow.
x Alarms
Load Power Off
The UPS is no longer protecting its load devices and there is no
utility voltage powering the devices.
x Alarms
Battery Test Failed
An automatic battery test failed. Battery replacement is imminent.
x Alarms
Site Wiring Fault
There is no ground connection between utility power and the UPS,
or the line and neutral connections between utility power and the
UPS are reversed. This is disabled for 200 V and 208 V
configurations.
Battery Data
Select Battery Data on the Main Menu to display the amount of charge on the battery.
Main Menu
→ Battery Data
When the UPS goes into Battery mode, the graph shows the remaining battery energy in
10 percent increments. This example shows a battery charged to 100 percent.
Battery Discharge
|❚▌▌▌▌▌▌▌▌▌▌|
Firmware Version
Select Firmware Version from the Main Menu to view the firmware versions for the UPS
components.
Main Menu
→ Firmware Version
This menu selection shows the control board firmware version.
Control Board
Version x. x x
This menu selection shows the communication board firmware version.
Communication Bd
Version x. x x