UPS R6000 Models User Guide

LCD Configuration and Status
3-10 HP Uninterruptible Power System R6000 Models User Guide
System Setup
Select System Setup from the Main Menu to change the system configuration. To change the
system setup, a password is required.
1. Choose the first digit using the up and down arrow keys on the Center button.
2. Press the right arrow key on the Center button to move to the next digit.
3. To change a digit, use the left arrow key on the Center button to go back.
4. After the entire password has been entered, press the Enter button.
NOTE: The password must be six characters long. The default password is “COMPAQ.”
Enter Password
COMPAQ
Set Hardware Configuration
Select Set HW Config from the System Setup menu to set up load segments and batteries for
the UPS.
System Setup
→ Set HW Config
Table 3-5 lists the options under the Set HW Config menu.
Table 3-5: Set HW Config Options
LCD Display Explanation
Set HW Config
→ Load Segments
Accesses the Load Segments option.
Load Segments
(0-5)
Allows specification of the number of individually controllable load
segments (from 1 to 5).
Set HW Config
→ Battery Amp-Hr
Accesses the Battery Amp-Hr option.
Battery Amp-Hr
Internal 0-25
Sets the Amp-Hour Rating of each cabinet, or configures the number
of external battery cabinets.
Choose 5 A-H for the UPS batteries, and 5 A-H for each additional
ERM, using the Center and Enter buttons.