UPS R6000 Models User Guide

LCD Configuration and Status
HP Uninterruptible Power System R6000 Models User Guide 3-13
Set Voltage
Select Set Voltage from the System Setup menu to set the UPS voltage.
CAUTION: Use the switch on the rear panel to place the UPS in manual Bypass mode. Then,
press the Standby button on the front panel to place the UPS in Standby mode before setting
the UPS voltage.
The options for voltage are 200, 208, 220, 230, 240, 208/230 Auto Sensing,
and 230 Extended. An asterisk (*) signifies the current configuration.
Set Voltage
* 208 V
Set Site Fault
Select Set Site Fault to enable or disable the Site Wiring Fault alarm. An asterisk (*) signifies
the current configuration.
Set Site Fault
* Enable
Set Sleep Mode
Select Set Sleep Mode from the System Setup menu to enable or disable Sleep mode. An
asterisk (*) signifies the current configuration.
NOTE: When Sleep mode is enabled, if the UPS is supplying battery power and the load on the UPS is
less than eight percent, the UPS switches to Sleep mode and the UPS turns off .
Set Sleep Mode
* Enable