HP RDX DL Server module installation instructions (5697-2006, August 2012)

Print Specification

569702006 – RDX DL Storage Module flyer (Eng/Fre/Ger/Jap)

Size Finished – 210mm x 148mm (A5 portrait)

Colours Printed 1/0.

Printed in black on one side only.

Material 100gsm recycled white.

Paper should contain at least 50% total recycled fibre with at least

10% post-consumer paper

Finishing Trim to 210mm x 148mm (A5).

Artwork Adobe Acrobat PDF

This part number, and all the material and processes used to produce it, must comply with

the latest version of "HP Standard 011 General Specification for the Environment"

(URL http://www.hp.com/hpinfo/globalcitizenship/environment/pdf/gse.pdf)

PAGE 1
Print Specification 569702006 – RDX DL Storage Module flyer (Eng/Fre/Ger/Jap) Size Finished – 210mm x 148mm (A5 portrait) Colours Printed 1/0. Printed in black on one side only. Material 100gsm recycled white. Paper should contain at least 50% total recycled fibre with at least 10% post-consumer paper Finishing Trim to 210mm x 148mm (A5).
PAGE 2
5697-2006 RDX DL Storage Module Flyer front.pdf 1 27/06/2012 12:10 HP RDX Removable Disk Backup System DL Server Module Installing the unit HP RDX DL Server Module is an internal assembly for a Proliant DL server. It is supplied with a USB and a power cable. 1. Power down the server, remove the power cord and then remove the access panel. 2. If an optical drive is already installed, remove it, leaving the SATA cable connected to the system board.
PAGE 3
5697-2006 RDX DL Storage Module Flyer back.pdf 1 27/06/2012 12:11 7. If you wish to use the optical drive, remove the blank from the HP RDX DL Server Module and insert the CD or DVD drive that you removed in step 2. Reconnect the SATA cable to the rear of the optical drive. 8. Push the HP RDX DL Server Module fully into the bay and secure it using the screws that you removed in step 3. 1 Install HP RDX DL Server Module 2 Secure with screws 9.