ColorSpan Legacy System Control - User Guide

A-6 Problems and Solutions
PostScript Error The interpreter detected an error in the
PostScript code and processing could not
continue. Sometimes caused by overly
complex graphics.
Simplify the image and send it
again. Check the PS Output log
for exact text of the error mes-
sage.
PostScript VM
Error
Insufficient PostScript Virtual Memory
(VM).
Delete unneeded files from the
RIP Saver queue or add an exter-
nal disk drive.
Print Cancelled Job was cancelled by the user before print-
ing was complete.
If available, move the RIP Saver
job back to the standard or pri-
ority output queue, or send the
job again.
Printed Job was RIPed, printed, and saved as a RIP
Saver file.
You can print this to the same
printer type by moving it to the
standard or priority output
queue.
Printer
Interrupted
Printer turned off or disconnected during
printing.
If available, move the RIP Saver
job back to the standard or pri-
ority output queue, or send the
job again.
Printer Manual
Feed
Manual feed was selected in the port or job
configuration but the color copier is not
configured for manual feed.
Configure the color copier for
manual feed.
Removed RIP
Saver
File was removed from the temporary RIP
Saver queue to make room for processing
or storing newer files.
Send the job again.
RIP Error May be a problem with the file sent. Send the job again. If error
recurs, call Technical Support.
RIP Restarted RIP was restarted by the user before the job
was finished processing.
Send the file again.
Uncalibrated
Printer
AutoSet was unable to run successfully in
unattended mode.
Run AutoSet, note and correct
error, and move the job to any
Output queue.
Unsupported
Printer
The job was RIPed for a printer that is not
supported by this print server.
Create the job for a printer sup-
ported by the server and send it
again.
Job Disposition What Happened What to do