HP StorageWorks B-Series Multi-protocol Router Blade Installation Guide (A7990-90002, June 2006)

Operating the B-Series MP Router blade24
Table 4 shows the B-Series MP Router blade LEDs. <Link>Table 4 describes the LEDs and their
actions.
Table 4 Port side LED patterns during normal operation
LED name LED color Hardware status Recommended action
Power
Status
No light Blade does not have incoming
power.
• Verify that the 4/256 SAN
Director is operational.
• Verify that the B-Series MP
Router blade is seated
correctly.
• Verify that the power slider
switch is in the up position.
If the unit still does not power up,
the unit may be faulty.
Contact HP if necessary.
Steady green Blade has valid power. No action required.
System
Status
No light Blade is either healthy or does
not have power.
Verify that the power status LED is
green.
Steady amber
(for more than
five seconds)
Boot failed, the blade is faulty.
The blade displays a steady
amber during boot or POST,
this is normal and does not
indicate a fault.
Perform the following steps:
• Reboot the blade.
• Check the error logs for
information on the failure.
Contact HP if necessary.
Slow-flashing
amber (on 2
seconds; then
off 2 seconds)
Attention is required. The
Blade is not seated correctly or
is faulty.
Check the error log for details on
the cause of the status.
Pull the blade out and reseat it.
If the LED continues to flash,
contact your switch service
provider.
Fast-flashing
amber (on 1/2
second; then off
1/2 second)
Attention is required.
Environmental range
exceeded.
Check the error log for details on
the cause of the status.
Check for out-of-bounds
environmental condition and
correct it.
If the LED continues to flash,
contact HP.