HP StorageWorks B-Series Multi-protocol Router Blade Installation Guide (A7990-90002, June 2006)

B-Series Multi-protocol Router blade installation guide 25
Port Status No light Indicates one of the following:
• No signal or light carrier
(media or cable) detected.
• Blade may be currently
initializing.
• Connected device is
configured in an offline
state
• Verify the power LED is on,
and check the SFP and cable.
• Verify the blade is not currently
being initialized.
• Verify the status of the
connected device.
Steady green Port is online (connected to
external device) but has no
traffic.
No action required.
Slow-flashing
green (on 1
second; then off
1 second)
Port is online but segmented
because of a loopback cable
or incompatible switch
connection.
Verify that the correct device is
attached to the blade.
Fast-flashing
green (on 1/4
second; then off
1/4 second)
Port is online and an internal
loopback diagnostic test is
running.
No action required.
Flickering green Port is online and frames are
flowing through the port.
No action required.
Steady amber Port is receiving light or signal
carrier, but it is not online yet.
No action required.
Slow-flashing
amber (on 2
seconds; then
off 2 seconds)
Port is disabled because of
diagnostics or the
portDisable command.
Reset the port.
The
portCfgPersistentDisable
command is persistent across
reboots in Fabric OS v5.0.1.
Fast-flashing
amber (on 1/2
second; then off
1/2 second)
SFP or port is faulty. Replace the SFP.
Reset the port.
Table 4 Port side LED patterns during normal operation (continued)
LED name LED color Hardware status Recommended action