HP StorageWorks SAN Virtualization Services Platform Data Path Module user guide (5697-8058, March 2009)

See also
“Create debug command” on page 22
“Load debug command” on page 38
“Reset debug command” on page 47
“Save debug command” on page 50
“Set debug command” on page 50
“Watch debug command” on page 71
Show eth command
Returns the configuration—IP address, subnet mask, and gateway—for the specified Ethernet interface.
Syntax
show eth [interface]
Keyword values
[interface]
Ethernet interface that you are showing: MGMT, GE1, GE2, or GE3
family
IPv4, IPv6
See also
“Disable eth command” on page 26
“Enable eth command” on page 31
“Modify eth command” on page 40
“Set eth command” on page 51
“Show eths command” on page 58
Show eths command
Returns the configuration—IP address, subnet mask, MAC base address, and gateway—for the four
Ethernet interfaces: MGMT, GE1, GE2, or GE3.
Syntax
show eths
See also
“Disable eth command” on page 26
“Enable eth command” on page 31
“Modify eth command” on page 40
CLI commands58