Service Processor (GSP or MP) - User Guide, Second Edition
A MP Commands
Command Reference: Service Processor (MP or GSP) Commands
Table A-1 lists the commands available from the service processor command menu (the MP:CM>
or GSP:CM> prompt).
The following categories of commands are available:
• “Service Commands — Service Processor (MP or GSP)” (page 27).
• “Status Commands — Service Processor (MP or GSP)” (page 27).
• “System and Access Configuration Commands — Service Processor (MP or GSP)” (page 28).
Some commands are restricted to users with Operator or Administrator authority. Also note that
the available set of commands may differ depending on the utility revision level and server
hardware model.
For details on these commands, use the help (HE: Help) feature at the service processor Main
menu. Enter the command name at the MP:HELP or GSP:HELP prompt for syntax, restrictions,
and other information.
Table A-1 Service Processor (MP or GSP) Command Reference
DescriptionCommand
Service Commands — Service Processor (MP or GSP) Commands for general server complex administration and
nPartition management.
Boot an nPartition past Boot is Blocked (BIB)
BO
Display FRU information of an entity
DF
Return to the Main menu
MA
Modem reset
MR
Activate/deactivate a PCI card
PCIOLAD
Power entities on or off
PE
Reset entity
RE
Reset an nPartition for reconfiguration; the nPartition remains inactive, in the shutdown
for reconfig state
RR
Reset an nPartition
RS
Send a TOC signal to an nPartition
TC
Broadcast a message to all users of the MP Command Handler
TE
Margin the voltage in a cabinet
VM
Display a list of MP connected users
WHO
Status Commands — Service Processor (MP or GSP) Commands for displaying hardware and nPartition information.
Display nPartition cell assignments
CP
Display the list of available commands
HE
Display IO chassis/cell connectivity
IO
Display LAN connected console status
LS
Display the status of the modem
MS
Display detailed power and hardware configuration status
PS
Display revisions of all firmware entities in the complex
SYSREV
Command Reference: Service Processor (MP or GSP) Commands 27