product update: hp server tc2100 network operating system (NOS) installation (English)

HP Part Number 5971-4537, Doc # 5971-4537-1 '"&$(!" $'
Printed in October 2001 2
Section 3. Perform NetWare SBS 5.1 Installation
The installation of NetWare 5.1 contains several phases:
• Phase 1 – Start the Installation
• Phase 2 – Install HP Drivers
• Phase 3 – Configure the Network and IDE Drivers
PHASE 1 – Start the Installation
NOTE If your hard drive contains data or is not new, HP recommends to use a utility such as FDISK to
erase all data and partitions from your hard drive.
1. Boot your HP Server on a DOS bootable utility diskette.
NOTE You can boot from the NetWare 5 License diskette. Novell DOS 7 and all required DOS utilities
(FDISK, FORMAT, EDIT) are included on the diskette.
2. Type FDISK to create a 250 MB primary DOS partition on the primary drive (C:). Remember to make it the active
(bootable) partition. The computer will restart and boot on the DOS bootable utility diskette again.
3. Format and transfer DOS system files to the partition by typing:
A:\>FORMAT C: /X /S
4. Insert the HP Disk NW (created with the Startup-CD) and type:
A:\>PREPARE
to automatically create new directories, copy the necessary drivers and configure the DOS boot.
5. Remove the diskette and reboot the server.
6. Insert the Netware SBS 5.1 CD, then type:
C:\>D:
D:\>INSTALL
7. Select the Appropriate Language if prompted.
8. Press F10 to Accept the License Agreement.
9. Press Enter to setup “a new server” then scroll down and choose Continue.
10. Modify or accept the server settings, the regional settings, as well as the mouse and video configuration.
PHASE 2 – Install HP Drivers
1. The installation program then detects your hardware and attempt to match the drivers to the hardware. It displays a
driver summary screen.