HP Serviceguard for Linux Version A.11.16 Release Notes, Third Edition, August 2006

Serviceguard for Linux Version A.11.16 Release Notes
Compatibility Information and Installation Requirements
Chapter 1 35
where
version represents the version number for the pidentd that
was last installed.
Follow the instructions in the README file in the directory of each
driver.
If you have installed a new OS version, you must run a convert
program. This will convert the binary file (cmclconfig) to its new
release format.
To run the program on the upgraded node, enter :
# SGGSBIN/convert
NOTE There are additional steps required for nodes running SLES9 or Red
Hat EL 4. You need to update all existing package control scripts on
each node as follows (update_cntl_scripts is the update command
that modifies the package control scripts to handle differences
between LVM and LVM2;
old_script is an example of a package
control script):
a. # cp
old_script old_script .orig
b. # update_cntl_scripts old_script .orig old_script
7. Reboot the node.
8. After the node has rebooted, verify the cluster status with a
cmviewcl command, and also verify all file systems with fsck.
9. Restart Serviceguard on this node with command cmrunnode.
Check that the node joins the cluster successfully, and if necessary,
move packages back onto the node.
10. Edit the /etc/rc.config.d/cmcluster file (on SUSE
/opt/cmcluster/conf/cmcluster.rc) to include the following line:
AUTOSTART_CMCLD = 1
11. Repeat this process for each node in the cluster.