Managing HP Serviceguard for Linux, Sixth Edition, August 2006

Cluster and Package Maintenance
Reviewing Cluster and Package States with the cmviewcl Command
Chapter 7 221
Subnet up 0 0 15.13.168.0
Node_Switching_Parameters:
NODE_TYPE STATUS SWITCHING NAME
Primary up enabled ftsys10
Alternate up enabled ftsys9 (current)
NODE STATUS STATE
ftsys10 up running
Network_Parameters:
INTERFACE STATUS NAME
PRIMARY up eth0
PRIMARY up eth1
Now pkg2 is running on node ftsys9. Note that it is still disabled from
switching.
Status After Package Switching is Enabled
The following command changes package status back to Auto Run
Enabled:
# cmmodpkg -e pkg2
The output of the cmviewcl command is now as follows:
CLUSTER STATUS
example up
NODE STATUS STATE
ftsys9 up running
PACKAGE STATUS STATE AUTO_RUN NODE
pkg1 up running enabled ftsys9
pkg2 up running enabled ftsys9
NODE STATUS STATE
ftsys10 up running
Both packages are now running on ftsys9 and pkg2 is enabled for
switching. Ftsys10 is running the daemon and no packages are running
on ftsys10.