Metrocluster EMC SRDF Version A.09.01 Release Notes, September 2010 (B6264-90032)

NOTE: On Integrity platforms, if EMC PowerPath is used for Consistency Group
configuration:
• PowerPath version 5.0.0 or higher
NOTE: To configure Consistency Groups using the RDF Enginuity Consistency Assist
(RDF-ECA), install the EMC Solutions Enabler software. You need not install the
PowerPath software.
HP-UX 11i v3:
• EMC Solutions Enabler versions 7.0, 7.1, and 7.1.x.
For more information on supported versions of Solutions Enabler, see the
Serviceguard Disaster Recovery Products Compatibility and Feature Matrix available at
http://www.hp.com/go/hpux-serviceguard-docs —> HP Metrocluster.
• Multi-threaded SYMAPI run-time library.
HP 9000 platforms, 32-bit multi-threaded SYMAPI library must be installed.
• Symmetrix microcode level
NOTE: For the supported Symmetrix microcode level on HP-UX 11i v2 and HP-UX
11i v3, see the Serviceguard Disaster Recovery Products Compatibility and Feature Matrix
(Metrocluster with EMC SRDF) available at http://www.hp.com/go/
hpux-serviceguard-docs —> HP Metrocluster.
For more details on supported microcode levels with SRDF and its features, refer to
the relevant Solutions Enabler Support Matrix at the EMC documentation Web site.
Installing Metrocluster/SRDF
Metrocluster/SRDF can be installed while the system is running in multi-user mode
using the following steps:
1. Run swinstall(1m) to install Metrocluster/SRDF product from a SD depot.
(Skip this step if the software has been preinstalled.) The software will reside in
the following two directories:
• /opt/cmcluster/toolkit/SGSRDF
• /usr/sbin
2. Install the SymCLI software on each node that has data residing on the EMC
Symmetrix arrays.
Changes to Script Templates in A.05.00 and Later
The following variables have been added to provide new functionality:
Compatibility Information and Installation Requirements 13