Advanced Data Guarding User Guide

2-4 Advanced Data Guarding for the Smart Array 5300 Controller Reference Guide
Compaq Confidential – Need to Know Required
Writer: John Turner Project: Advanced Data Guarding for the Smart Array 5300 Controller Reference Guide Comments: final draft
Part Number: 188270-xx1 File Name: c-ch2 Installation.doc Last Saved On: 12/11/00 12:04 PM
4. Use one thumb to press the tab at the top of the rear end outward 2(a)
while using the other thumb to gently press the other end of the module
2(b) into the connector and slot on the controller board.
5. Replace the Smart Array 5300 controller in the server.
6. Replace or close the access panel.
7. Reconnect peripherals and power.
8. Power on the system.
Removing the Enabler Module
When replacing a Smart Array 5300 controller, you may want to remove the
RAID ADG Enabler Module from the old controller and install it onto the new
controller.
To remove the RAID ADG Enabler Module:
1. Perform the preliminary steps listed earlier in this chapter.
2. Press the innermost plastic clip under the controller board towards the
other clip 1, and push the module out of the board 2.
1
2
Figure 2-4. Removing the RAID ADG Enabler Module