Embedded Compaq Smart Array 5i Plus Controller Installation Instructions For Compaq ProLiant ML370 Generation 2 Servers

Kit Contents
• Compaq Smart Array 5i Plus Controller
• Battery module
• Cable for battery module, approximately 35 cm (14 inches)
• VHDCI cable
• Two screws for VHDCI cable
Safety Information
WARNING: To reduce the risk of personal injury or damage to
the equipment, consult the safety information and user
documentation provided with the computer before attempting the
installation.
Many personal computers are capable of providing energy levels
that are considered hazardous. These computers are intended to
be serviced by qualified personnel trained to deal with these
hazards. Do not remove enclosures or attempt to bypass any
interlocks that may be provided for the purpose of removing
these hazardous conditions.
CAUTION: Discharge of static electricity from a finger or other
conductor can damage the server. To prevent electrostatic damage
to the equipment:
• Transport parts in static-safe containers.
• Place the container on a grounded surface before removing
the part.
• Be sure that you are always grounded while installing the
battery module.
• Avoid touching pins, leads, or circuitry.
CAUTION: Observe the following limitations when using the
battery module:
• Do not transfer the battery module to a different model server.
• Do not add or remove the battery module while an array
capacity expansion, RAID level migration, or stripe size
migration is in progress.
Regulatory Notice
The rating label on the device gives the class (A or B) of the equipment. Class B devices have an FCC logo
or ID on the label. Class A devices do not have an FCC logo or ID on the label. After you determine the
class of the device, refer to the server user guide for complete regulatory compliance notices.