Manualshelf

HP Smart Array E500 Controller User Guide

ManualsBrandsHP ManualsComputer AccessoriesHP Smart Array E500/256 2-ports Ext PCIe x8 SAS Controller
11121314151617181920
Upgrading or replacing controller options 19
o
If the LED is not lit, disconnect the battery cable from the cache.
4. Remove the controller from the server and place it on a firm, flat, nonconductive surface.
5. Remove the existing cache from the controller by pulling at both ends of the cache module with
equal force.
6. Install the new cache on the controller. Press firmly above each connector to ensure good electrical
contact. (If the cache is not properly connected, the controller cannot boot.)
7. Replace the controller in the server.
8. If the previous cache was connected to a battery pack, reconnect the battery cable to the new
cache.