AM312A Smart Array P812/1GB Controller for HP Integrity Servers Installation Guide

2. Enter the ioscan -kfnd ciss command:
# ioscan -kfnd ciss
If the Smart Array Controller software is installed correctly, the generated output looks similar
to this:
# ioscan -kfnd ciss
Class I H/W Path Driver S/W State H/W Type Description
==========================================================================
ext_bus 5 0/6/0/0/0/0/1/0/0/0 ciss CLAIMED INTERFACE PCIe SAS SmartArray P400 RAID Controller
/dev/ciss5
If the software is not installed correctly, reinstall it using swinstall. See “Installing software”
(page 6).
Configuring a Smart Array series controller as a boot device
This section describes the additional steps you must follow to enable your system to boot from
logical drives on a Smart Array Series Controller.
NOTE: To create logical drives, use the Option ROM Configuration for Arrays (ORCA). See
“Creating a logical drive” (page 23). For more information, see the HP Smart Array SAS Controllers
for Integrity Servers Support Guide at:
http://www.hp.com/go/smart-array-raid-docs
Click the link for your HP-UX version. Support guides are listed alphabetically in the “User guide”
section.
Configuring a Smart Array series controller as a boot device 7