HP A7143A RAID160 SA Controller Support Guide, February 2007

Installing the RAID160 SA Controller
Verifying the Installation
Chapter 4
48
HWEnable11i B.11.11.0306.4 Hardware Enablement Patches for HP-UX 11i, June
2003
OnlineDiag B.11.11.12.01 HPUX 11.11 Support Tools Bundle, Jun 2003
RAID-00 B.11.11.01 PCI RAID; Supptd HW=A5856A
RAID-01 B.11.11.%08 RAID160; Supptd HW=A7143A
perl B.5.6.1.C Perl Programming Language
#
# Product(s) not contained in a Bundle:
#
BullseyeCover11 6.1.6 HP-UX 11
LIF-LOAD B.11.11.07.11 HP LIF LOAD Tools
The RAID-01 bundle is highlighted for emphasis.
Step 2. Issue the ioscan -kfn | grep ciss command:
ioscan -kfn | grep ciss
If the RAID160 SA controller software is installed correctly, the generated output will look similar
to this:
# ioscan -kfn | grep ciss
ext_bus 6 0/6/2/0 ciss CLAIMED INTERFACE PCI 4-Channel RAID160 SA SCSI
controller (A7143A)
/dev/ciss6
If the software is not installed correctly, re-install it using swinstall (see “Installing Software for
the RAID160 SA Controller” on page 35).