HP A7143A RAID160 SA Controller Support Guide, February 2007

Installing the RAID160 SA Controller
RAID160 SA Controller Firmware
Chapter 4
55
| * * * * |
| * * |
| |
| * * |
| * * * * |
(Ch 3)---> * * * * <--- (Ch 4)
| * * * * |
| * * |
| |
| |
~ ~ ~ ~ ~
******************************************************************************
**** End of SAUTIL Output ****
******************************************************************************
The firmware version that is in the ROM on the RAID160 SA controller (/dev/ciss6), is version 2.92.
Updating the RAID160 SA Firmware
The sautil command syntax for updating RAID160 SA controller firmware is:
sautil <device_file> download_hba_fw <fw_image>
where:
<device_file> is the controller device file. The device file for the RAID160 controller can be determined
by running the ioscan -kfn command as illustrated in “Determining the RAID160 SA Device File” on
page 50.
<fw_image> is the file path for the firmware version you want to install on the RAID160 SA controller.
The file path for the latest RAID160 SA controller firmware file can be found in the /opt/raidsa/bin/
directory in the SW depot download bundle. See “Installing Software for the RAID160 SA Controller” on
page 35, for the complete file path.
When the sautil <device_file> download_hba_fw <fw_image> command is issued, the firmware version
that is currently installed will be listed along with the firmware version you selected to replace it with. You
will have the opportunity to proceed with the download or cancel:
# sautil /dev/ciss6 download_hba_fw /opt/raidsa/bin/MAXWELL332.BIN
******************************************************************************
**** ****
**** S A U T I L S u p p o r t U t i l i t y ****
**** ****
**** for the HP A7143A RAID160 SA SCSI Adapter ****
**** ****