HP A7143A RAID160 SA Controller Support Guide

Configuring the RAID160 SA Controller
saconfig Configuration CLI
Chapter 5 107
Issue the man saconfig command to view the saconfig manpage for
more details on the saconfig command.
Before running the saconfig command to configure the storage devices
connected to a RAID160 SA controller, you will need to know the device
file for the RAID160 SA controller.
Determining the RAID160 SA Device File
The device file for the RAID160 SA controller can be determined from
the output of the ioscan -kfn command. An example of a portion of the
ioscan -kfn output listing the RAID160 SA device file follows:
# ioscan -kfn
Class I H/W Path Driver S/W State H/W Type Description
=============================================================================
root 0 root CLAIMED BUS_NEXUS
ioa 0 0 sba CLAIMED BUS_NEXUS System Bus
Adapter (582)
ba 0 0/0 lba CLAIMED BUS_NEXUS Local PCI Bus
Adapter (782)
lan 0 0/0/0/0 btlan CLAIMED INTERFACE HP PCI
10/100Base-TX Core
/dev/diag/lan0 /dev/ether0 /dev/lan0
target 2 0/0/1/1.15 tgt CLAIMED DEVICE
disk 0 0/0/1/1.15.0 sdisk CLAIMED DEVICE HP 73.4GMAN3735MC
/dev/dsk/c1t15d0 /dev/rdsk/c1t15d0
ext_bus 6 0/6/0/0 ciss CLAIMED INTERFACE PCI 4-Channel
RAID160 SA SCSI Adapter (A7143A)
/dev/ciss6
target 7 0/6/0/0.0 tgt NO_HW DEVICE
target 8 0/6/0/0.7 tgt CLAIMED DEVICE
The device file for the RAID160 SA controller in the example above is
/dev/ciss6.
Displaying the RAID160 SA Configuration
To display the physical disks connected to a RAID160 SA controller, as
well as any logical drives and spare drives that have been configured,
issue the saconfig <dev_file> command, where <dev_file>
represents the device file for the RAID160 SA controller.