HP Smart Array 6400 Series Controllers Support Guide, September 2007
# sautil /dev/ciss4 -s
******************************************************************************
**** ****
**** S A U T I L S u p p o r t U t i l i t y ****
**** ****
**** for the HP SmartArray RAID Controller Family ****
**** ****
**** version A.02.09
**** ****
**** (C) Copyright 2003-2005 Hewlett-Packard Development Company, L.P. ****
******************************************************************************
---- DRIVER INFORMATION ------------------------------------------------------
Driver State........................ READY
---- CONTROLLER INFORMATION --------------------------------------------------
Controller Product Number........... A9891A
Controller Product Name............. HP PCI-X SmartArray 6404 (Ch A1, A2)
Hardware Path....................... 0/3/1/0/4/0
Serial Number....................... P57820FDAPHKEU
Device File......................... /dev/ciss4
Hardware Revision................... 'B'
Firmware Revision (in ROM).......... 1.92
# of Logical Drives................. 1
# of Physical Disks Configured...... 2
# of Physical Disks Detected........ 2
o
o (content has been omitted)
o
******************************************************************************
**** End of SAUTIL Output ****
******************************************************************************
In this example, the firmware version in the ROM on the Smart Array Controller (/dev/ciss4),
is version 1.92.
Updating the Smart Array Controller Firmware
The sautil command syntax for updating Smart Array Controller firmware is:
#sautil <device_file> download_ctlr_fw <fw_image>
where:
<device_file>
The controller device file. Determine the device file for the Smart Array
Controller by running the ioscan -kfnd ciss command as described
in “Determining the Smart Array 6400 Series Controller Device File”
(page 33).
<fw_image>
The file path for the firmware version you want to install on the Smart
Array Controller.
When you enter the sautil <device_file> download_ctlr_fw <fw_image> command,
the currently installed firmware version is listed along with the firmware version you selected
to replace it with. You can either proceed with the download or cancel:
# sautil /dev/ciss4 download_ctlr_fw CYBORG226.BIN
******************************************************************************
**** ****
**** S A U T I L S u p p o r t U t i l i t y ****
**** ****
**** for the HP SmartArray RAID Controller Family ****
**** ****
**** version A.02.09 ****
**** ****
**** (C) Copyright 2003-2005 Hewlett-Packard Development Company, L.P. ****
Smart Array 6400 Series Controller Firmware 35