HP Smart Array 6400 Series Controllers Support Guide, September 2007

ManualsBrandsHP ManualsNetwork HardwareHP Smart Array (RAID) Host Bus Adapters

Device Type...................................... DISK

Disk Capacity....................................

Fault Tolerance Mode................ RAID 1+0 (Disk Mirroring)

Logical Drive Size.................. 17361 MB

Logical Drive Status................ OK

# of Participating Physical Disks... 2

Participating Physical Disk(s)...... Ch:ID

2: 5

2: 8

Participating Spare Disk(s)......... Ch:ID

none

Stripe Size......................... 128 KB

Logical Drive Cache Status.......... cache enabled

Configuration Signature............. 0xAAA644E9

Media Exchange Detected?............ no

Device Status.................................... OK

Device Vendor ID................................. COMPAQ

Device Product ID................................ BF01885A34

Device Serial Number............................. 3JY0SKFV000074215FN0

Device Firmware Version.......................... HPB6

SCSI Transfer Rate............................... Ultra-320

Reserved Area (cfg/status info).................. 557.1 KB (0.6 MB)

Block Size (bytes/sector)........................ 512 bytes

HP Disk Stamped?................................. yes

Last Failure Reason.............................. none

Physical Disk Flags:

Disk present and operational................... yes

Non-disk device detected....................... no

Wide SCSI transfer enabled..................... yes

Synchronous (Fast/Ultra) transfer enabled...... yes

Narrow disk tray detected...................... no

Wide transfer failed, reverted to narrow....... no

Ultra SCSI transfer enabled.................... yes

Ultra-2 SCSI transfer enabled.................. yes

S.M.A.R.T. supported........................... yes

S.M.A.R.T. errors (in factory M&P data)........ no

S.M.A.R.T. enabled............................. yes

S.M.A.R.T. errors (in powerup M&P data)........ no

Attached to external channel................... yes

Configured in a logical drive.................. yes

Configured as a spare disk..................... no

Disk write cache enabled at spin up............ no

Running in DT clocking mode.................... yes

Supports DT clocking mode only................. no

Supports DT and ST clocking modes.............. yes

Running in U320 mode........................... yes

Packetized SCSI supported...................... yes

Supports redundant controller operation........ yes

Disk write cache enabled in current page....... no

Disk write cache disabled in default page...... yes

QAS capable (U320 only)........................ yes

Currently running QAS (U320 only).............. yes

---- SCSI DEVICE 2:15 [PROCESSOR] --------------------------------------------

Connector Location............................... external

Channel Number................................... 2

SCSI ID.......................................... 15

The sautil Command 61