HP Smart Array 6400 Series Controllers Support Guide, September 2007

A Controller Specifications

This appendix provides specification details for HP Smart Array 6402 and Smart Array 6404

Controllers.

This appendix addresses the following topics:

Table A-1: “Smart Array 6402 Controller Specifications” (page 65)

Table A-2: “Smart Array 6404 Controller Specifications” (page 65)

Smart Array 6400 Series Controller Specifications

Table A-1 provides specification details for HP Smart Array 6402 Controllers.

Table A-1 Smart Array 6402 Controller Specifications

31.2 cm x 10.7 cm x 1.8 cm

(12.3 in x 4.2 in x 0.7 in)

Dimensions (excluding bracket)

Typically 12-18 WPower Required

2 NiMH rechargeable battery packs, 3.6 V eachBattery

10 to 35 degrees C (50 to 95 degrees F)Operating Temperature Range

-20 to 55 degrees C (-4 to 121 degrees F)Storage/Shipping Temperature Range

10% to 70% (Storage/Shipping 5% to 90%)Operating Relative Humidity (noncondensing)

0, 1, 1+0, 5, and ADGRAID Levels Supported

PowerPC 405 at 266 MHzProcessor Type

Up to 2.0 GB/s at 266 MHz (DDR, 72 bit)DDR SDRAM Bus Transfer Rate

Complies with PCI-X revision 1PCI Specification

3.3 V, 64 bit, WIDE PCI-X or PCI slotPCI-X Bus Connector Type

Up to 1.0 GB/s at 133 MHz (64-bit)PCI-X Bus Transfer Rate

2Number of Channels

15 (14 in an external enclosure)Maximum Disks per Channel

LVD onlySCSI Bus Type

68 pin Wide Internal, VHDCI ExternalSCSI Connector Type

Termination required, and provided automatically on supported

HP systems

SCSI Termination

Up to 320 MB/s (160 MHz DDR) per channelSCSI Transfer Rate

192 MB (128 MB in the cache module and 64 MB on the board)Cache Size

Table A-2 provides specification details for HP Smart Array 6404 Controllers.