HP Smart Array P700m Controller for Integrity Servers Installation Guide, Second Edition

NOTE: Pressing F8 at the ORCA prompt might not start ORCA on all terminals. If ORCA does
not start when you press F8, reboot the system and press the key sequence ESC 8 at the ORCA
prompt to start ORCA.
Figure 1-1 ORCA Main Menu Screen
To create a logical drive using ORCA, follow these steps:
1. Select Create Logical Drive.
The screen displays a list of available (unconfigured) physical drives and the valid RAID
options for the system.
2. Use the arrow keys, space bar, and Tab key to navigate around the screen and set up the
logical drive, including an online spare drive if one is required.
NOTE: You cannot use ORCA to configure a single spare drive to be shared among several
arrays. To configure shared spare drives, you must use the saconfig command on the CLI.
3. Press Enter to accept the settings.
4. Press F8 to confirm the settings and save the configuration.
After several seconds, the Configuration Saved screen appears.
5. Press Enter to continue.
6. Create another logical drive by repeating steps 1-5 if necessary.
For more information on using ORCA, see the HP Smart Array SAS Controllers for Integrity Servers
Support Guide.
14 HP-UX installation