HP Smart Array P800 Controller for Integrity Servers Installation Guide, December 2007

3. Compare the installed firmware version to the minimum recommended firmware version
found in the HP Smart Array RAID Controllers Support Matrix at:
http://docs.hp.com/en/netcom.html
If the controller firmware meets the minimum recommended version, no further action is
necessary.
Downloading the Firmware Update
To locate and download firmware for the Smart Array P800 Controller, follow these steps:
1. Go to the Business Support Center, at:
http://www.hp.com/go/bizsupport
2. Search for “Smart Array P800”.
3. In the “Narrow search using only” section, click Drivers and software.
4. Locate and click the link for the firmware download package.
5. Review the installation instructions and release notes on the download page.
6. Download the firmware.
7. Follow the procedures supplied with the update package to install the firmware update.
Updating the Controller Firmware
NOTE: The following is a generic procedure to update firmware from the EFI shell. HP
recommends that you follow the procedures supplied with the update package to install the
firmware update.
Use saupdate from the EFI Shell to update the firmware image on the controller.:
To update the controller firmware with saupdate, follow these steps:
12 HP-UX Installation