HP Smart Array P800 Controller for Integrity Servers Installation Guide, December 2007

1. Prepare to run saupdate from the Offline Diagnostics CD or the EFI partition:

• To run saupdate from the Offline Diagnostic CD:

a. Place the Offline Diagnostic CD containing saupdate.efi in the CD drive before

booting the system.

b. Boot the system to the EFI Shell prompt.

c. Locate the cdrom entry in the list of mapped devices, and change to the device by

entering its associated fs number (for example, fs0) under EFI Shell prompt.

d. If the EFI utility is not located in the root directory, move to the directory where

the file is located, for example:

fs0:\> cd \EFI\HP\TOOLS\IO_CARDS\SmartArray

• To run saupdate from the EFI partition:

a. Download the SA EFI update utility saupdate.efi and copy it to the EFI partition.

b. Boot the system to the EFI Shell and change directories to the EFI partition.

c. If the EFI utility is not located in the root directory, move to the directory where

the file is located, for example:

fs0:\> cd \EFI\HP\TOOLS\IO_CARDS\SmartArray

2. • Use saupdate LIST to display all detected Smart Array controllers along with the

active firmware versions. For example:

fs0:\EFI\TOOLS> saupdate list

************************************************************************

Smart Array Offline Firmware Update Utility

Version 2.07.09.02

Seg Bus Dev Func Description Version

0 8 0 0 HP Smart Array P800 4.10

External Enclosures Connected :

Index Description Version

2 MSA70 2.04

In this example, the system contains one MSA70 enclosure at segment 0, bus 8, device 0,

function 0, index 2; enclosure firmware 2.04 is installed.

Downloading the Enclosure Firmware

To locate and download firmware for HP StorageWorks enclosures, follow these steps:

1. Go to the HP Software & Driver Downloads website, at:

http://welcome.hp.com/country/us/en/support.html?pageDisplay=drivers

2. Search for the name of your enclosure; for example, “MSA60” or “MSA70”.

3. In the search results, click Cross operating system (BIOS, Firmware, Diagnostics, etc.).

4. Click Download to download the firmware package.

Updating the Enclosure Firmware

NOTE: The following is a generic procedure to update firmware from the EFI shell. HP

recommends that you follow the procedures supplied with the update package to install the

firmware update.

Use saupdate from the EFI Shell to update the firmware image on the enclosure.

To update the enclosure firmware with saupdate, follow these steps:

Verifying and Updating Enclosure Firmware Offline 15