HP Smart Array P800 Controller for Integrity Servers Installation Guide, December 2007

fs0:\EFI\TOOLS> saupdate list

************************************************************************

Smart Array Offline Firmware Update Utility

Version 2.07.09.02

Seg Bus Dev Func Description Version

0 8 0 0 HP Smart Array P800 4.10

External Enclosures Connected :

Index Description Version

2 MSA70 2.04

In this example, the system contains one MSA70 enclosure at segment 0, bus 8, device 0, function

0, index 2; enclosure firmware 2.04 is installed.

Downloading the Firmware Update, If Needed

To locate and download firmware for HP StorageWorks enclosures, follow these steps:

1. Go to the HP Software & Driver Downloads website, at:

http://welcome.hp.com/country/us/en/support.html?pageDisplay=drivers

2. Search for the name of your enclosure; for example, “MSA60” or “MSA70”.

3. In the search results, click Cross operating system (BIOS, Firmware, Diagnostics, etc.).

4. Click the Download button to download the firmware package.

Updating the Enclosure Firmware

NOTE: This section provides a generic procedure to update firmware from the EFI shell. HP

recommends that you follow the procedures supplied with the update package to install the

firmware update.

Use saupdate from the EFI Shell to update the firmware image on the HP Smart Array controller.

Follow one of these two procedures to run saupdate:

• If you are using saupdate from the Offline Diagnostic CD:

1. Download the firmware and copy it to the EFI partition.

2. Place the Offline Diagnostic CD containing saupdate.efi in the CD drive before booting

the system.

3. Boot the system to the EFI Shell prompt.

4. Locate the cdrom entry in the list of mapped devices, and change to the device by typing

its associated fs number (for example, fs0) under EFI Shell prompt.

5. If the EFI utility and firmware image files are not located in the root directory, move to the

directory in which these files are located, for example:

fs0:\>cd \EFI\HP\TOOLS\IO_CARDS\SmartArray

IMPORTANT: Both saupdate.efi and the firmware image file must be located in the same

directory. If they are not, copy them both to the EFI partition. Run the saupdate.efi using the

fs0:\> saupdate command.

• If you are not using the Offline Diagnostic CD:

1. Download the SA EFI update utility saupdate.efi and copy it to the EFI partition.

2. Download the firmware and copy it to the EFI partition.

Verifying and Updating Enclosure Firmware Offline 31