RAID-01 (ciss) B.11.31.
© Copyright 2008 Hewlett-Packard Development Company, L.P. Legal Notices Hewlett-Packard makes no warranty of any kind with regard to this document, including, but not limited to, the implied warranties of merchantability and fitness for a particular purpose. Hewlett-Packard shall not be held liable for errors contained herein or direct, indirect, special, incidental or consequential damages in connection with the furnishing, performance, or use of this material. Confidential computer software.
This document provides information about the September 2008 release of the RAID-01 bundle for HP-UX 11i v3. 1 RAID-01 Overview The RAID-01 bundle contains the ciss driver for the HP A9890A, A9891A, A7143A, AD397A and AD348A (P400), and AD335A (P800) host bus adapters running on HP-UX 11i v3 platforms. This release includes the following: Component Description Version ciss HP-UX driver B.11.31.0809 saconfig HP-UX Smart Array command line configuration utility A.01.
2 New and Changed Features in This Release The following feature is new with this version of RAID-01: • Pre-enablement RAID-01 B.11.31.0809 pre-enables support for future Smart Array host bus adapters. 3 Problems Fixed in This Version There are no defects or fixes included in RAID-01 at the time of this publication. 4 Known Problems and Limitations This section provides a list of problems and limitations known to HP when these release notes were published. If workarounds are available, they are included.
Corrective Action: Reconnect the cables or reinsert the disks, then reset the Smart Array controller using the sautil reset_ctlr command. After the controller is reset, ioscan correctly reports the status of the disks as CLAIMED. • Disconnected external storage enclosures are not properly detected by ioscan. If you disconnect all cables connecting a Smart Array controller to external storage enclosures, saconfig and sautil show the status of the logical drives as FAILED.
5.1 Required Software • OS Platform and Version Compatibility Before installing the Smart Array Controller software, install a supported HP-UX Operating System. To determine the supported HP-UX versions for your system, see the HP Smart Array RAID Controllers Support Matrix at: http://docs.hp.com/en/netcom.html • Locating Software for the Smart Array Controllers The HP-UX driver and utilities are not shipped with the controller, but are available through from Software Depot at: http://www.hp.
