RAID-01 (ciss) B.11.31.
© Copyright 2010 Hewlett-Packard Development Company, L.P. Legal Notices Hewlett-Packard makes no warranty of any kind with regard to this document, including, but not limited to, the implied warranties of merchantability and fitness for a particular purpose. Hewlett-Packard shall not be held liable for errors contained herein or direct, indirect, special, incidental or consequential damages in connection with the furnishing, performance, or use of this material. Confidential computer software.
This document provides updated information about the September 2010 release of the RAID-01 bundle for HP-UX 11i v3. Changes since edition 1 • • • Smart Array AM311A and AM312A are added to “Supported controllers” (page 3). Smart Array AM311A and AM312A are added to “Minimum supported RAID-01 (ciss) versions for HP-UX 11i v3, by adapter” (page 4).
1.1 Driver versions Table 3 lists the minimum supported RAID-01 ciss driver version for each Smart Array host bus adapter: Table 3 Minimum supported RAID-01 (ciss) versions for HP-UX 11i v3, by adapter Adapter Minimum driver version A7143A, A9890A, A9891A B.11.31 Smart Array P400 B.11.31.0709.01 Smart Array P410i B.11.31.1005 Smart Array P411 B.11.31.1005 Smart Array P700m B.11.31.0903 Smart Array P800 B.11.31.0712 Smart Array P812 B.11.31.1005 2 New and changed features in this release 2.
— — — HP StorageWorks D2600 and D2700 Series enclosures connected to an HP AM311A or AM312A controller. Embedded SAS Expander in AM312A controller. SATA hard disks in an HP StorageWorks D2600 and D2700 Series enclosures connected to an HP AM311A or AM312A controller, when SATA support is added in a future firmware update. WARNING! HP AM311A and AM312A controllers do not support SATA disks in their initial release with adapter firmware version 3.30.
Table 6 HP-UX 11i v3 March 2010 Fixes — RAID-01 B.11.31.1003 SR Number Description QXCR1000863084 I/O hangs occur under heavy load. QXCR1000914639 MSI-X interrupts are not assigned with HBA locality taken into consideration. QXCR1000934272 The ciss driver does not support the GET_SCSI_DISK_BINDING ioctl. QXCR1000934287 The ciss driver causes a panic in rare circumstances on systems with very low memory.
NOTE: If you remove the dynamically loaded ciss driver while it is in use, or if you remove the statically loaded ciss driver at any time, you must perform a reboot. This is normal behavior under these conditions, and is not affected by patch PHCO_36356. • Automatic hot-plug is not detected. The HP Smart Array Controllers do not automatically detect the hot-plug of internal disks. Corrective Action: After replacing a physical disk, run the sautil command with the scan option. 4.
6. Connect the MSA2300 Series enclosure. No special considerations apply when performing a clean installation of AR0909 on servers that are not configured with an MSA2300 Series enclosure to AR0909. You can download the RAID-01 B.11.31.0909 bundle from the HP website at http:// www.hp.com/go/softwaredepot. Search for RAID-01. • SAS Storage Enclosure Status display issue in sautil command output.
Corrective Action: Reset the Smart Array controller using the sautil reset_ctlr command. When the controller is reset, ioscan correctly reports the status of the disks as NO_HW. • Controller fails when two connectors are used on the same channel. Each channel has two connectors (one internal and one external), but only one connector can be used per channel at any given time.
Click the link for your HP-UX version. • Support Matrix documents are listed alphabetically in the “General reference” section. • Release notes are listed alphabetically in the “Getting started” section. • Installation guides are listed alphabetically in the “Setup and install — general” section. • Support guides are listed alphabetically in the “User guide” section. 7 Software availability in native languages The RAID-01 product is available only in the English language.
