RAID-01 (ciss) B.11.31.1203.01 Mass Storage Driver Release Notes

Table 3 Minimum supported RAID-01 (ciss) versions for HP-UX 11i v3, by adapter (continued)
Minimum driver versionAdapter
B.11.31.1005Smart Array P410i
B.11.31.1005Smart Array P411
B.11.31.0903Smart Array P700m
B.11.31.1109Smart Array P711m
B.11.31.0712Smart Array P800
B.11.31.1005Smart Array P812
2 New and changed features in this release
2.1 New features
The following features are new with this version of RAID-01:
• Logical drives can now be created on physical disks larger than 2 TB. (QXCR1001160371)
The ciss driver now supports creating logical drives with physical disks larger than 2TB using
saconfig(1M).
2.2 Changed features
The following features are changed with this version of RAID-01:
• Diagnostic message filtering is added to the ciss driver. (QXCR1001146707)
The ciss driver is changed to log only critical messages to the system log file.
3 Problems fixed in this version
Table 4 HP-UX 11i v3 March 2012 fixes — RAID-01 B.11.31.1203.01
DescriptionSR number
P2000 IO Hang recovery takes long time in rare scenariosQXCR1001194782
Table 5 HP-UX 11i v3 March 2012 fixes — RAID-01 B.11.31.1203
DescriptionSR number
New CPU ID is not propagated to mass storage stack after an interrupt migration.QXCR1001147832
Firmware failures occur with D2200sb enclosures.QXCR1001152548
The ciss driver does not notify ESCSI stack with ESCSI_TP_OFFLINE event.QXCR1001154483
The sautil(1M) utility shows the mode as RAID instead of HBA when the HBA is in the
offline state.
QXCR1001159876
Additional statistics are needed in sautil(1M).QXCR1001181576
Problems fixed in recent versions
Table 6 HP-UX 11i v3 September 2011 fixes — RAID-01 B.11.31.1109
DescriptionSR number
On cards controlled by the ciss driver, the ANSI version is overwritten with an incorrect
lower value.
QXCR1001119028
The scsimgr replace_wwid command fails on ciss devices.QXCR1001095075
4