Updating HP StorageWorks MSA60 and MSA70 Enclosure Firmware Offline Using DFDUTIL.EFI, Edition 1, March 2009
* Downloading firmware to a disk MAY destroy the data on the *
* disk. Make sure you have made the necessary backups. *
**************************************************************
**************************************************************
* About to download firmware MSA60_212.FRM onto disk(s): 8.
**************************************************************
Do you wish to continue with the download (y/[n]/q)? y
**************************************************************
* WARNING! *
* DO NOT INTERRUPT THIS PROCESS OR THE DISK MAY BE DAMAGED! *
**************************************************************
**************************************************************
* Please wait while disk 8 at 0/3/0/0/0/0.15.0 is updated
* from revision 2.11 to 2.12.
**************************************************************
Please wait a few minutes for file verification of the downloaded firmware ....
NOTE: There may be no response from the system for up to 10 minutes ....
Please wait 600 secs while the MSA is reinitializing.
600 seconds left ..........
590 seconds left ..........
[...]
20 seconds left ..........
10 seconds left ..........
Done!
Please wait while the device ROMs are updating.
30 seconds left ..........
20 seconds left ..........
10 seconds left ..........
Done!
**************************************************************
* ATTENTION! *
* Due to the MSA update(s), a system power cycle is advised. *
**************************************************************
**************************************************************
* Firmware downloaded SUCCESSFULLY! *
* --------------------------------- *
* Power off & on device(s) to activate the new firmware. *
**************************************************************
DFDUTIL>
3. To exit DFDUTIL, enter the exit all command at the DFDUTIL prompt:
DFDUTIL> exit all
ImageHandle <100FEE0F690> SLMOD.EFI Unloaded Successfully
4. To reset the system, enter the reset command at the EFI shell prompt. For example:
fs0:> reset
Verifying the Firmware Update
1. Move to the directory that contains ODE and DFDUTIL.
6








