HP StorageWorks MSL Library Extender user guide (AQ746-96005, September 2009)
Table Of Contents
- HP StorageWorks MSL Library Extender user guide
- Table of Contents
- 1 Features and overview
- 2 Configuring and operating an extended library
- 3 Installing the Library Extender
- Identifying product components
- Downloading product documentation
- Determining the master and lower Library
- Saving the Library configurations
- Upgrading the Library firmware
- Enabling extended mode
- Removing the cartridges from the Libraries
- Powering off the Libraries
- Positioning the Libraries in a rack
- Relocating tape drives
- Removing and replacing drive bay covers
- Removing the USB device and Ethernet cable from the lower Library
- Extending the pull-out tab
- Aligning the Libraries
- Installing the Extender
- Powering on the extended library
- Verifying the installation
- 4 Using diagnostic tools and troubleshooting
- 5 Servicing the Library Extender
- Replacing the Library Extender
- Removing the Library Extender
- Removing a cartridge from the Extender
- Repackaging the Library Extender
- Releasing the magazines manually
- 6 Support and other resources
- A Technical specifications
- B Electrostatic discharge
- C Regulatory compliance notices
- Glossary
- Index
1 Features and overview
The Library Extender combines two HP StorageWorks MSL Tape Libraries to create a single extended
library. Before installing the Extender, the Libraries must be installed in the rack rails supplied with
the Libraries in adjacent rack locations, one Library above the other. See the example shown in Figure
1.
Figure 1 Library Extender installed with two MSL4048 Tape Libraries
.
The Extender occupies the lower half-height drive bay of the upper Library and the top half-height
drive bay of the lower Library.
The upper Library controls the extended library and is called the master Library. The extended library
uses only the master Library OCP, USB port, and Ethernet connection.
The lower Library is controlled by the master Library. The lower Library OCP, USB port, and Ethernet
connection are not used by the extended library.
Table 1 Supported configurations
Total full-height drive
bays
Total half-height drive
bays
Total slotsLower LibraryMaster Library
1+03+172MSL2024MSL4048
1+13+396MSL4048MSL4048
3+03+1120MSL2024MSL8096
3+13+3144MSL4048MSL8096
HP StorageWorks MSL Library Extender user guide 11