HP StorageWorks MSL Library Extender user guide (AQ746-96005, September 2009)
Table Of Contents
- HP StorageWorks MSL Library Extender user guide
- Table of Contents
- 1 Features and overview
- 2 Configuring and operating an extended library
- 3 Installing the Library Extender
- Identifying product components
- Downloading product documentation
- Determining the master and lower Library
- Saving the Library configurations
- Upgrading the Library firmware
- Enabling extended mode
- Removing the cartridges from the Libraries
- Powering off the Libraries
- Positioning the Libraries in a rack
- Relocating tape drives
- Removing and replacing drive bay covers
- Removing the USB device and Ethernet cable from the lower Library
- Extending the pull-out tab
- Aligning the Libraries
- Installing the Extender
- Powering on the extended library
- Verifying the installation
- 4 Using diagnostic tools and troubleshooting
- 5 Servicing the Library Extender
- Replacing the Library Extender
- Removing the Library Extender
- Removing a cartridge from the Extender
- Repackaging the Library Extender
- Releasing the magazines manually
- 6 Support and other resources
- A Technical specifications
- B Electrostatic discharge
- C Regulatory compliance notices
- Glossary
- Index
6. Move the tape drives, if necessary, to open the drive bays that will be used by the Extender.
NOTE:
In an MSL4048, a full-height tape drive will only operate in the two upper or two lower
half-height drive locations. Do not install a full height tape drive in the middle half-height
drive bays of an MSL4048 Tape Library.
7. Install the Extender.
8. Tighten the captive rack attachment screws on the front of the Libraries.
9. Power on both Libraries and verify that the three Extender LEDs are illuminated.
Rack stability
Rack stability protects personnel and equipment.
WARNING!
To reduce the risk of personal injury or damage to equipment:
• Extend leveling jacks to the floor.
• Ensure that the full weight of the rack rests on the leveling jacks.
• Install stabilizing feet on the rack.
• In multiple-rack installations, fasten racks together securely.
• Extend only one rack component at a time. Racks can become unstable if more than one component
is extended.
Features and overview14