HP StorageWorks MSL Library Extender user guide (AQ746-96005, September 2009)

Table Of Contents
Use the OCP or RMI to open the magazines and remove the tapes from the Library. The magazines
with the tapes in them may also be removed from the Library.
See the HP StorageWorks MSL2024, MSL4048, and MSL8096 user and service guide for instructions
on opening or removing the magazines.
Powering off the Libraries
Press the power button on the front panel to power off each Library as shown in Figure 11, page 31.
Figure 11 Library power button
.
Positioning the Libraries in a rack
Figure 12 Two MSL4048 Tape Libraries installed in a rack in the rack rails supplied with the Libraries
in adjacent rack locations
.
Before installing the Library Extender, the two Libraries must be installed in a rack in the rack rails
supplied with the Library and the master Library must be installed directly above the lower Library in
the adjacent rack location as shown in Figure 12, page 31.
If you do not need to move either of the Libraries, skip to Relocating tape drives, page 35.
HP StorageWorks MSL Library Extender user guide 31